Set up instructions: QUICKFEET Football sensors 

Preparations:

Remark: Please build up the QUICKFEET Trainer completely before installing the sensors. Therefore you need the QUICKFEET Setup document.

• Connect the hardware with 1 or 2 people for a functional test. Like shown on the first photo on the next page.
• Open the velcro’s from the sleeves on both sides to hang the sensors in the bungee.
• Connect all male and female cables to the sensors. After finishing this you can press ON the master unit. 

Part list:

• 8x QUICKFEET football sensors
• 1x Master BLE unit with USB C plug
• 7x cable female
• 7x cable male
• 2x cable Master

Sensor wiring:

As a first step, please connect the hardware as shown on the image for a functional test:

• When the LED is flashing, please re-check the wiring and the fit of the connectors.
• When the LED lights permanently after turning ON the master box, the sensors are wired correctly.
• You are now ready to install the sensors. Press the ON/OFF button for three seconds to turn off the master
• Next, please open the male/female couplings (7x between the slaves) and decouple the master completely
• You should end up with the eight slaves (wired with two cables each) and an unwired master box.

Installation:

Open the velcro on both sides of the sleeves and push the sleeve ends so that you can see the bungees in the center areas.

Now take the slaves and hang them into the bungees in the panel center (the I/O writing should face the inside of the Trainer. Lead the cables through the compressed sleeve and then stretch the sleeve over the full panel size again and close the two.  You should end up with the sensor hanging inside the sleeve (behind the sleeve print) and with the two cable ends coming out of the sleeve ends (one per side). 

Now close the seven male/female couplings and connect the master with the two remaining cables (compare with the Sensor Wiring Scheme).

Depending on the master’s battery level, you may also need to connect the master to a power source with a standard USB-C charger (not included).

WARNING: Avoid humidity at any plug connection – the system is conforming to IP44 only when wired correctly and the master’s USB-C plug is used. Now turn ON the master BLE unit and check if the LED lights permanently (you already know what to do, when the LED flashes. 

Before training:

As the sensors can move and fall off the bungee, it is always a good idea to check if the sensors hang in the panel center before you start playing. Simply push ON/OFF button on the master BLE unit to turn on the full system.

When you have finished your training, turn off the master unit (press the ON/OFF button for 3 seconds) to save battery. When you want to disassemble the Trainer, then open the male/female couplings (7x between the slaves) and decoupe completely. We advice to charge the master BLE unit after use so that you can enjoy a full battery level at the next training session.

App and sensor connection:
You are now able to install and connect the QUICKFEET app with the QUICKFEET sensors.

• Simply install the QUICKFEET app
• Create an account by email.
• Once you are registered, connect the app to the BLE master unit. After calibration you are ready to play!